| 1. |
Mode
| (1) |
Configuration State
| A. |
All sensors should be in the Low
Line (Base) state. |
| B. |
In Low Line (Base) configuration,
sensor transmissions occur every 3 minutes 20 seconds
(nominal) and pressure is measured every 20
seconds. | |
| (2) |
Normal Fixed Base State
| A. |
Sensor transmissions continue at
the Low Line (Base) configuration defined rates until
the state is either changed by LF command or by the
sensor detecting a condition that requires a temporary
change to another
state. |
| B. |
The LF command to this state must
contain the sensors
ID. | |
| (3) |
Storage Auto State:
| A. |
This state is a Low current
consumption state. |
| B. |
Sensors are in this state when
they first arrive at the dealership (either on the
vehicle or as replacement
spares). |
| C. |
In this state, the sensor does not
measure pressure / temperature / battery
level. |
| D. |
The sensor will not transmit in
this state unless requested to do so by the initiate
command. | |
| (4) |
Alert State:
| A. |
The sensor automatically enters
this state if the measured temperature exceeds 230
°F(110 °C) and over temperature shutdown is
likely. |
| B. |
In this state, pressure is
measured every 4 seconds and RF data transmitted every 4
seconds. |
| C. |
The state lasts for 1 minute if it
is pressure triggered. |
| D. |
This state is alse entered when a
3 psi change in pressure from the last RF transmission
occurs.
|
Sensor mode is used to
configure sensor between high line and low line
system. TPM sensor for LM should be set to low
line. | | | | |
